1
0

Shopping cart

There are currently no items in your shopping cart.

    Products

    FC7070/01 AquaTrio Vacuuming and Mopping System
    Please be aware that your product may differ in colour from this picture but the support information is the same
    View product

    AquaTrio Vacuuming and Mopping System

    FC7070/01

    My Philips AquaTrio stops working after ten seconds

    If your Philips AquaTrio stops working after ten seconds, this can have several causes. Check all possible causes and solutions here in the following order.

    There is no water in the clean water tank or the dirty water tank is full

    Fill the clean water tank with water and make sure the dirty water tank is empty.

    The lid of the mopping nozzle is not closed properly

    Sometimes the lid appears to be properly closed, while in reality, it isn't. Make sure it is closed properly.

    Closing the lid of the mopping nozzle

    The Active Protection System has been activated

    When the Active Protection System of your Philips AquaTrio has been activated, the brushes do not rotate and no water is applied to the floor.

    To reset the Active Protection System:

    1. Switch off the appliance and pull the plug out of the wall socket.
    2. Open the mopping nozzle lid, remove the mopping brush cover and take out the object.
    3. If the active protection system was activated because the mopping brushes are too wet, remove the mopping brushes and squeeze them over the sink.
    4. Place the dry mopping brushes back into the appliance.
    5. Replace the mopping brush cover and close the mopping nozzle lid. Press the mopping nozzle lid to lock it ('click').
    Play Pause

    The hose inside the appliance has not yet filled with water

    When you use your Philips AquaTrio for the first time, it might be the case that the hose inside the appliance is not yet filled with water. In this case, when you switch on your appliance, the tank full/tank empty light flashes and the appliance switches off again.

    If this happens, try to switch on your appliance continuously until the tank full/tank empty light stays off and your appliance stays on. When the light stays off and your Philips AquaTrio has been running for about 30 seconds, water will be applied to the floor.

    If the above solutions did not solve your problem, please contact us.

    The information on this page applies to the following models: FC7070/01 .

    Register your product
    Register your product

    Keep track of your product warranty coverage

    Qualify for cash-back, gifts and special offers

    Get easy access to product support